“JAN VAN GENT”
Fast open launch

Price: 141.000 excl. tax
Technical details
- Material : Fiberglass
hull and deck, teak lining and deck.
- Loa : 10.35 meter
- Beam: 3.30 meter
- Draft : 0.72 meter
- Year
build: New
- Engine : 1x 315 hp Yanmar (smaller engines possible, please
enquire)
- Speed: max: 24 knots

Standard
equipment
- Polyester
hull with Iso-NPG gel coat
- Rope fender
all round with bow fender attached
- Stainless
steel bow strip with stainless steel support for the fender
- Hull colour of your
choice
- Identification
(ID) chip embedded in the hull
- Fitted with a
Jan van Gent hydro-wing (55 hp version and above)
- Motor housing
doubly isolated with an aluminium motor casing
- Automatic
sensor-activated fire extinguishing system built in under the motor casing
- Fitted with a
bilge pump
- 1 battery
rated at 106Ah
- Battery
charger with quayside power connection in the steering position
- 70 / 120 / 280 litre stainless
steel tank for diesel fuel
- 4 blade
bronze propeller
- Stainless
steel water-lubricated propeller axle
- Hydraulic
steering
- Bow thruster (including auxiliary battery) with joystick
control on the steering position
- Solid teak
wheel with stainless steel fittings on both sides (diameter 100 cm)
- Rudder with
polyester attachments, solid teak fins, stainless steel fittings
- Solid teak
control panel, recessed into the steering position
- Solid teak
gunwales
- Self-bailing
compartments (skipper's compartment) with polyester floors; there is an
anti-slip grid structure and they are fitted with solid teak blocks on
both compartment floors
- Anchor locker
hatch, foredeck storage hatch, engine compartment hatch and stern storage
hatch all fitted with recessed, solid teak with rubber lining.
- Engine
compartment hatch and foredeck storage hatch fitted with pneumatic springs
- 2 cold
storage units with hatches covered with an anti-slip polyester layer
- Electrical
cooling unit with control thermostat fitted in the refrigerator
- 6 storage
chests fitted into the compartment's benches
- Port-hole in
the foredeck compartment wall
- Navigation
lights in stainless steel housing, mounted beneath the bow fender
- 360º top
light mounted on the gunwale
- 4 x stainless
steel cleats, positioned on the gunwales
- 4 x stainless
steel attachments for the fenders, in casings by the gangboards
on the inside
- Teak table
with 4 stainless steel legs, completely detachable
- Lighting
fitted in both compartments
- Chemical
toilet built into foredeck compartment
- Shower fitted
in the aft compartment + 70
litre stainless steel water tank
- Full set of
cushions on all benches and sun decks, including a back support for the
helmsman
- Stainless
steel steering position bracket with a hand-held spotlight / signalling
light attached, with a 12 Volt connection inside the steering position
- sprayhood in
colour of your choice
- Rear tent in
colour of your choice
- Protective
cover for the steering position
- Stainless
steel sea railing fixed to the gunwales
- 2 x plastic
mooring line set and 2 x fenders
- Turned teak
flagpole with flag
- Gel-shield
epoxy coating and anti-fouling treatment of the submerged hull parts
Options:
- Radio / CD
player + 4 splash-proof speaker units
- Bimini top
with stainless steel framework, in cover
- Bimini-top
extension
- Cruiser
emergency raft (4 person) in holder
- Satellite
navigation
- Homokinetic
coupling

FRANCAIS:
Equipment standard;
- Coque
en polyester gelcoat iso
- npg
- Défense en câble tout autour et défense d'étrave à mailles
- Bande de proue en inox avec support de bourrelet de défense en inox
- Couleur de la coque au choix
- Puce d'identification - (ID)-chip -coulée dans la coque
- Jan van Gent, hydrowing monté (à partir du
modèle 55 cv)
- Carter à double isolation dans un compartiment moteur en aluminium
- Système d'extinction automatique commandé par capteurs, incorporé dans
le compartiment moteur
- pompe
de cale installée
- Accu l
x 106 A/h
- Chargeur d'accus avec raccordement au courant de quai sur le poste de
manoeuvre
- Réservoir de carburant diesel de 70 / 120 / 280 litres en inox
- Hélice
en bronze à 4 pales
- Arbre d'hélice en inox RVS lubrifié à l'eau
- Commande hydraulique
- Hélice avant (accu auxiliaire inclus) avec commande par manette sur le
poste de manoeuvre
- Roue de gouvernail en teck massif avec armature en inox sur les côtés
(diamètre de 100 cm)
- gouvernail accroché en polyester, à joues en teck massif, avec
armature en inox
- Panneau de contrôle en teck massif, intégré dans le poste de manoeuvre
- Plat-bord en teck massif
- Timoneries autovideuses (compartiment du
conducteur / timonerie) avec sol en polyester pourvue d'une structure
gaufrée antidérapante garnie de blocs de grilles en teck massif sur les
deux sols des timoneries
- Trappe de l'écubier d'ancre,trappe du
compartiment du pont avant, trappe du compartiment moteur et trappe du
compartiment arrière du bateau orné de teck massif caoutchouté.
- Trappe du compartiment moteur et trappe du compartiment du pont avant
pourvues d'amortisseurs au gaz
- 2 réfrigérateurs dont les trappes sont pourvues
d'une couche de polyester antidérapante
- Élément réfrigérant électrique avec commande par thermostat intégrée
dans le réfrigérateur
- 6 caissons intégrés dans les bancs de la timonerie
- Hublot dans la paroi de la timonerie du pont avant
- feux de route dans boîtier inox, fixés sous la défense d'étrave
- Feu de mât visible de tous les côtés, monté sur le plat-bord
- 4 taquets en inox et teck, fixés sur le plat-bord
- Côté intérieur du plat-bord : 4 fixations de défenses en inox
intégrées dans le carter
- Table en teck sur 4 pieds en inox, entièrement démontable
- Éclairage de timonerie présent dans les deux compartiments
- Toilettes à sec intégrées dans le
compartiment du pont avant
- Douche intégrée dans le compartiment arrière + réservoir de 70 litres en inox
- Jeu de coussins complet sur tous les bancs et solariums, boudin pour
le dos du conducteur inclus
- Étrier du poste de manoeuvre en inox sur lequel est monté un
projecteur "à main" à raccordement 12 Volts dans le poste de
manoeuvre
- Capuchon de buse couleur au choix
- Tente arrière couleur au choix
- Housse de protection du poste de manoeuvre
- Rambarde en inox fixée sur le plat-bord
- 2 jeux de cordes d'amarrage en matière synthétique et 2 défenses
- Hampe de pavillon en teck tourné, avec pavillon
- Recouvrement epoxy gelshield
et traitement antifouling de la partie sous eau
Conforme aux normes de couleurs NKIP/CE
Options :
- Radio / lecteur de CD + 4 haut-parleurs protégés contre les
éclaboussures
- Biminitop, arceaux inox dans une housse
- Rallonge Biminitop
- Radeau de secours Cruiser (4 personnes) dans fixation
- Satellite de
navigation
- Accouplement homocinétique

